NEW - Apple iPhone 13 mini OEM Display OLED Touch Screen Digitizer Replacement. New screen directly from Apple.This listing is for an Apple iPhone 13 MINI service pack. In order to utilize the Face ID module included with the new OEM screen and/or prevent "unknown part" (doesn't effect functionality) notification, the iPhone would need screen calibration using an Apple certified software. This software is only available to Apple authorized repair centers. If you do not have access to this specialized software, you can reuse the original Face ID/speaker module (earpiece module pulled from old original screen and transferred to new screen) to keep Face ID functional. If this part is installed without calibration or the original earpiece module is damaged or not replaced with original module from old screen, Face ID will not work.
If the "selfie" camera assembly is damaged, that will also render Face ID non functional. This message has no impact on functionality of the screen itself. It is simply caused by a serial number not being copied over during calibration. NOTE: Transfer of earpiece module not required for iPhone 13, 13 pro, 13 mini or 13 pro max. Just pop old screen off and install new screen and have IOS 15.2 beta or higher installed.
Assuming new screen was properly installed, Face ID should remain functional without needing to transfer components from the old screen. Run apple calibration to remove "unknown part"message, otherwise ignore until it goes away. This item is in the category "Cell Phones & Accessories\Cell Phone & Smartphone Parts". The seller is "hakmods777" and is located in this country: US.This item can be shipped to United States.